bing tracking image

Nissan Altima Accessories and Parts Installation And Review Videos

     

Yakima Roof Rack Fairing Review - 2010 Nissan Altima- Video

Yakima Roof Rack Fairing Review - 2010 Nissan Altima

Today on our 2010 Nissan Altima, we'll be test fitting the 44 inch fairing for Yakima roof rack cross bars, part number Y07048. With our roof rack already assembled and installed, we'll begin by placing the fairing at the front of our Altima. We'll fit the clips around the front cross bar, and drop the bolt through the clip at each end, and then secure them with the wing nuts. As you secure your Yakima fairing, make sure that it centers with your Altima. With everything centered and secured, we're ready to head out on the road. That completes our test fit of the 44 inch Yakimafairing, part number Y07048on our 2010 Nissan Altima. more


Watch Video

9/27/2013 9:36:20 AM



Yakima Roof Rack Fairing Review - 2013 Nissan Altima- Video

Yakima Roof Rack Fairing Review - 2013 Nissan Altima

Today on our 2013 Nissan Altima well be test fitting the Yakima 44 inch fairing for Yakima round crossbars, part number Y07048. Well begin our test fit by simply placing the fairing onto the roof of our Altima. Well then loosen up the black wing nut and remove the silver bolt to put the bracket on the crossbar. Well then reenter the bolt and tighten down the bracket loosely. Well then wrap around the other two brackets and move to the other side of the vehicle where we can again loosen up the wing nut and remove the Allen bolt. Then we can attach that bracket around the underside of the front crossbar. more


Watch Video

7/16/2013 1:31:03 PM



Trailer Wiring Harness Installation - 2006 Nissan Altima 118151- Video

Trailer Wiring Harness Installation - 2006 Nissan Altima 118151

Today on this 2006 Nissan Altima we are going to install part number 119176 from Tow Ready. The first thing we need to do is get access to the trunk area of the vehicle. We need to pull back some of the interior components so we can get to the wiring. We removed the flooring material, now we are going to take off this panel right here. It is assembled along the top edge here but you can just pull on it and it should pop out. We will do the same thing with the plastic rivets here and here and get closer to the wiring. We can see where our main wire harness comes down through here and this goes on to the passenger side of the vehicle and this one goes straight to the driver side tail light. So we can get access to our wiring here and here. 00:49 more


Watch Video

11/12/2010 4:13:18 AM



  1